Subject: Potential new seal to stop leak in Ross PSRU
From: Paul
Date: 4/19/2000, 8:44 PM

Ed Anderson wrote:

Hi Folks,
    As some may of you may know, I have been searching for a more robust
seal for my Ross PSRU.  The National Seal that I have been using is rated at
5 psi in so far as its rating for holding against an oil leak.  Some
research on the web indicated that there were seals available that could
hold in oil at much higher pressures.

   Well, it took a little doing including visiting at least 3 businesses
specalizing in seals to find a replacement.  This seal will replace the
national seal.  The lip is .063" higher than the national but should present
no problem and it is rated to hold against 300 psi oil pressure. This is
overkill, but what the heck.   The surface speed is also higher than the 45
ft/sec of the Ross shaft.  The down side is it will take 4 weeks to get here
and it costs  around $65.00 or about 5 times what the national seal costs.
However, if it stops the leak it will be well worth it.  Will let you know
how it works out when I get it.

Ed
Ed Anderson
RV-6A N494BW Rotary Powered
Matthews NC
eanderson@carolina.rr.com

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org