Subject: Ed's new oil sump.
From: Paul
Date: 4/21/2000, 7:14 AM

Archie wrote:

If Ross is using a lip seal, and it is leaking, there may
be an eccentricity problem between the OD and ID of
the machined areas.
This type of seal works even better with slight pressure
on the backside. In fact, when we purposely create a
large amount of vacuum in the crankcase, we install
the seals in reverse.

When pressure builds up in the gearbox of a supercharger,
(sometimes up to 30 psi), the seals hold it well.
We install a pressure bleed,(similar to a fuel sump drain),
and release the pressure after each run. In the last three
engines of this type I have built, I have placed an inline
relief valve set to 4 psi, and it relieves into the crankcase.
Total cost is about $12.
Archie

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org