Subject: Plan D for pump in tank
From: Paul
Date: 4/22/2000, 5:03 AM

I woke up with this idea that since this system is totally dependent
on a working electrical system no selector valve is necessary for
the main feed lines or the return lines. Tank selection is
done entirely with the pump switches. This again further simplifies 
the system. It also eliminates the possibility of a high pressure leak
in the selector valve. 

However, when very low on fuel the return line could feed fuel into
the empty, non selected, tank and make it a little difficult to pick 
up that fuel again as it would have to flow through the cross connect. In 
that case I have added an emergency return line low pressure selector
valve. Normally this selector valve is left on both and the return
fuel goes to the tank with the least fuel.

When you get very low on fuel you could forward slip and transfer what
little fuel was left in the near empty tank and then operate the selector
valve to positively return all fuel to the selected tank.


Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

PUMP-IN-TANK-SYS.GIF