Subject: Plan D for pump in tank
From: Paul
Date: 4/23/2000, 3:17 PM

Scott Gettings wrote:

Guys,

WIth all the discussion about various fuel tank considerations, has there been any
thought or previous discussion regarding any better methods for measuring the fuel
level with something other than the common types of gages?   Header tanks and fat
tanks aren't much of an issue, but long, thin wing tanks are.  So are moving
senders and expensive capacitance probes that would require a "tower" to get an
accurate elevation on wing tanks with lots of dihedral.

We had a long thread on rec.aviation.homebuilt with Jim Weir participating, with
his (no moving parts) capacitance fuel gage re-designed to handle a small surface
area of opposing plates, as might be needed in a small tank or long, thin tank.
See his revised article at:  http://www.rst-engr.com/kitplanes/    in the July
2000 issue.   Certainly one nice, inexpensive solution.

Another idea that I have thought of (that I certainly don't have the engineering
expertise to do) is why not measure the difference in pressure at the bottom of a
tank with a sensitive pressure transducer relative to atmospheric pressure at a
reference transducer?  Provided some low-pressure, sensitive transducers are
available at a reasonable price (and of course could stand up to a gasoline
environment), wouldn't it be relatively easy to design a circuit that could be
calibrated against known fuel quantities in tanks of any shape or size?   With a
comparative probe outside the tank, any variations in pressure altitude would have
a reference point.

Comments are welcome as to any ideas, feasibility, insanity, etc. of this one.

Scott Gettings


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org