Mark Steitle wrote:

         Reply to:   RE: Intake manifolds.
Paul,
As I mentioned earlier, I will be needing a 3R flange.  Are there others out

there  too?  Now's the time to speak up guys!  To what address should I send the
flange template?

Mark

P.S.  Bob, how about it?

OK guys but you are going to have to finance them being made.
I will front the money for twenty or so two rotors flanges but
I think there will not be enough orders for three rotor
versions.

I will take the template over there and get a quote.
The guy I have choose  to do it is;

Robert Monetti at Hydro Jet
2635 Lavey Ct. Suite 1
Newbury Park CA 91320

phone 805 375 7099
fax   805 375 1029
cell  805 509 4532

Paul Lamar

VO wrote:

Paul,
I looking for 3R flange. Which type of material are you using?
I would be interested to have one and another for friend
of mine Rob (N115XL - Velocity XL RG, NA 20B). How much?
Delivery time?
Vlad
N1UT

3/8" thick  6061 T6 plate is weldable and relatively low cost.
Don't know the cost yet. It will be awhile as I am waiting on
some loaner manifolds or templates.

Here is a drawing of a two rotor six port engine Mike Wills
sent me. Please make a template out of this and check it on your
six port engines. I don't want to make a bunch and not have them fit.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org