<<Electric acuators do not give feedback on valve condition and cannot
overcome a
bit of extra resistance. They work until they don't.>>
norm2 wrote:
I am planning on using a high pressure pump (Bosch) one on each
tank. These
have a checkvalve built into the output fitting. To pump from the right
tank, power the right pump. To pump from the left tank, power the left
pump. The return fuel will be handled with a Pollack 6 port fuel selector
valve. Take the power leads from the pump to actuate the motor driven
valve, it will return fuel to the tank that is being pumped. In the event
that both pumps are powered (for takeoff, landing, or one pump
failure), the
valve stays where it is put. There is a switch in the valve that is
typically used to select which fuel sender to display on the vehicle
dashboard. This switch can be used to indicate to the cockpit where the
fuel is being returned. Given that you know where you are drawing fuel
from, a simple error light could be configured to tell you that the
valve is
stuck and you are returning to the opposite tank.
Norm,
This is the system (and the valve I think) that I had in mind. Is this
the valve that JC Whitney sells? This valve was mentioned in a previous
discussion here. I have yet to buy one and take a look at it. If you have
one and better yet if youve tested it I would be interested in hearing your
opinion as to how well it works and how well it appears to be made.
Since this valve (and most of the EFI pumps Ive seen) use hose barbs
rather than AN fittings what type of hose and clamps are you using?
Thanks,
Mike Wills
Hey guys the fuel system is critical. IMHO You should be using AN lines.
See Kinsler for stuff with AN fittings. This is probably the most
important system in your airplane. It does not pay to nickel and dime it.
An in-flight fire is a horrible way to die.
I hate to nag. Its a dirty job but somebody has to do it. :-)
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org