Bulent Aliev wrote:
I already had it in my plans to do the same modification if I could. It is so
simple in theory, I can not believe it Burt did not do it. Moving the prop hub
couple inches higher or lower will prevent the prop blades entering the wing wake
along the full length of the blade at the same time.
In a two blade prop is even worse. Both blades unload and load simultaneously.
Bulent
An interesting footnote. Most of the stress and noise mentioned here is
related to *radial* wakes. If the wake is along a radial of the prop shaft
then the affects are awful. Simply moving the wake a few inches (the more
the better) off radial will make the wake *sweep* across the prop blade
instead of impacting it all at once. The difference is remarkable. At
Moller moving a strut once resulted in a 20 dB noise reduction. This
means you too Perry, stay away from radial struts. Also, look at the
Aerospatial (sp?) helicopters sometime with the buried tail rotor. The
struts are in the form of an H. Most other buried rotors use similar methods.
Jeff Spitzer
Wow. That IS interesting. So those Rutan designs have the thrust line
at wing level. Moving the engine up a few inches will make it
quieter. That will give more room under the engine for the rad too.
Paul Lamar
Bulent Aliev wrote:
I already had it in my plans to do the same modification if I could. It is so
simple in theory, I can not believe it Burt did not do it. Moving the prop hub
couple inches higher or lower will prevent the prop blades entering the wing wake
along the full length of the blade at the same time.
In a two blade prop is even worse. Both blades unload and load simultaneously.
Bulent
Perhaps he was concerned with pitch down upon power application.
Amphibians with high mounted engines do that. I don't think it will
have much effect. Sure helps the prop clearance if you moved it up.
That is always a problem on a pusher.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org