Mike Wills wrote:

BTW guys I should mention that the dimensions for the 2 outer/upper ports
assume that the actuator barrel valves are removed. I think that both Bruce
and Tracy recommend removing the valve and then blending the port with JB
Weld but I havent reviewed Bruces tape in some time so could be wrong. If
you want to mod the barrel valve and then glue it in place in the side
housing that hole size should be reduced.

Mike Wills

Has anybody tried grinding out the separator between the upper hole
and the lower hole?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org