Subject: 89 four port intake manifold
From: Paul
Date: 4/26/2000, 7:58 PM


The items in question are air bleeds (one way valves) for the oil metering
system. If you use the stock oil metering system, you should use these. They
have a small orifice and check valve that effectively keeps manifold vacuum
from acting on the oil metering lines and pump. Without the bleeds, high
manifold vacuum will draw oil out of the line in a large "gulp," and then
when the throttle is advanced again there will be a lag while the pump
refills the line. This is certainly more of an issue in an automotive
application where high vacuum will occur on the overrun, but IMHO these
devices should be used for any application. One can see the effect even when
the throttle is "goosed" with no load, and the vacuum goes high on the
coast-down. On a turbo the failure mode would be to blow the oil out of the
air bleed instead of into the engine. NA I think the failure mode would be
very soft.

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com

Thanks Jon. Looks like another reason to mix two cycle oil with the gas.
Also sounds like an emissions issue. I think the latter engines
only use the two oil injectors in the rotor housing. Are these 
air bleeds used or needed there too? 

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org