Guys I need to borrow two stock intake manifolds. A six port version
and a four port version. I will pay shipping both ways.
I need these to get the holes in the right places.

I am going to make some light weight intake manifold flanges.
Probable about twenty six port and ten four port versions.
I will also look into getting some aluminum tube bent up
with the proper leg length, radius and diameter.
You can then cut and weld (or have welded) the tubing to suit.
It will be the Power Sport style wrap over manifold for side port
engines.

BTW If you put the injectors on the plug side of the
engine at the end of the tubes  you are less likely to burn the
fuel system plumbing and wiring in the event you have an engine fire
ignited by the exhaust system on the other side of the engine.

The idea is to sell a intake manifold kit at near cost.

I am tired of people wining about not being able to build intake manifolds

:-)

Chime in if you want one so I know how many to make up.

Paul Lamar

Ken Gillanders wrote:

I'm in for a four port. Early model four port '74 to '79 I think. My engine
has the seal groves in the rotor housings and not the end housings. I was
looking at Mazdatrix's site and there are a few choices for intake gaskets.
I'll send you the manifold if you want and I will pay the shipping if you
can solve this problem!!

Ken Gillanders

I have a four port but I am still waiting for Jim Phillips to
tell me what year it is.

I suspect that is a carb version you have. Can you make a plastic
template of the engine and send me that? See later messages for
a how to.

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org