Rich wrote:
Where can someone get a flapper valve?
Rich
You have to make them Rich. It is usually a flat piece of aluminum
piano hinged along the top closing a large hole in the wing rib
or tank baffle. It prevents fuel from sloshing to the outboard
part of the tank.
Gravity and back flow of fuel close it. Most kit planes use
them and instructions on how to make them are usually in the
plans. What type of airplane are you building?
Paul Lamar
I'm building a Zenith CH-801. There is nothing in the plans about
this.
The airplane uses aluminum fuel tanks fitted in-between the ribs.
They do sell an extended range tank as an option which is identical as
the regular tanks. I asked how it is hooked up. They said that the
outboard tanks are 'T'd together & the inboard tanks are 'T'd
together. The fuel selector will read something like: OUTBOARD INBOARD
OFF.
I may not need the flapper after all but if so, I'm guessing the
flapper doesn't need to create a seal, with an O-ring or anything,
right? Also I will have to figure out a way to make the flapper in a
fitting because the tanks would have to be connected with fuel lines
with the flapper fitting in between. NO room in-between the tanks.
Rich
Yes. It mainly slows the fuel from sloshing around in slips.
In a fitting it is called a one way valve.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org