Subject: 20B - Intake manifold flange
From: Paul
Date: 4/30/2000, 6:49 PM


Regarding the holes above the intake ports -- I don't have any direct 20B
experience, but on the 13B's, similar holes provide some air into the bore
that contains the fuel injector. The fuel injectors spray onto "mixing
plates" (small plastic pieces that I suppose are intended to break up the
fuel spray). The air from these holes also enters above the mixing plates.
The air is sourced from atmospheric pressure, so the effect will be greatest
at low throttle settings (high manifold vacuum). I would "guess" the issue is
primarily light load HC emissions. IIRC, some years did not have the air
bleeds, but I'm not really sure. Those 20B ports sure are large compared with
13B's!!!

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com

Bulent Aliev wrote:

My Cosmo 13 13B has identical size ports without the small holes. The plastic
diffusers under the injectors were present  on all the injectors. i would need 2
since they were very brittle and broke up. The top lip of the intake ports is
turned up and if you extend that angle to the flange, the ports will be about 1/4"
longer (taller). I am dealing with it right now. The small ports need 1 3/4" tube
to cover the port when shaped to fit. The big ones will take 2 1/8" or 2 1/4" tube
diam. I ordered U-bends from Burns stainless.
Bulent


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org