Harley Dixon wrote:

Perhaps the only way to get them out of there is tap them and

screw in a

screw and then pull them out.<<

I'm not sure of the exact location of these pins, and my

suggestion may not

work if there is not enough surface for a base for the lever

(enough to

locate the head of a pair of side cutting pliers) , but we used to

get

hardened pins out of blind holes in injection molds by using a

pair of side

cutters (to get a "bite" on the pin) and leveraging it against a

block of

hardwood or brass under the jaws (to protect the mating surface of

the

mold).

Working the pin out of the hole this way always worked, as long as

you

weren't going to reuse the pin.

Harley

Not much place to get a bite as the pins are flush. Grinding the
inside
of the diffuser until the end of the pins appear may be the best
way.

Paul Lamar

How about a small drill bit to drill througn the housing to the
 other side ? Then back drill a larger hole to allow the pin to
pass through ? Virg

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org