Subject: New Low height stock pump.
From: Paul
Date: 6/3/2000, 4:33 PM

Bill Freeman wrote:

Here is what I intend to do next to fix the stock pump.
I need to remove this section of the back wall so
the welder can weld in a new partition.

Paul Lamar

Paul,

Why isn't one of the available racing (external) water pumps
a good fix for this problem?  Seems like a blank-off plate
with a nicely rounded inlet and outlet fitting and an external
pump would be an elegant solution, improve the cowl line
fit problems, but may be more expensive.  Sounds like the
major surgery on the existing pump may be nearly as
expensive and not as certain of a good outcome.

But - since I have never really looked at one of these in real
life (while paying attention to the water pump) I may be
way off base.

Bill
Long EZ builder & pilot
mechanical engineer

Supposedly the racing pump from Mazda is very expensive and the only advantage
is it is lighter. It is still too high to fit a Lancair or Kis Cruiser.
The cavitation speed and flow rate is reputedly the same.

I may have found a welder that can weld in a new partition
without cutting the back off. I will know more on Monday. Modifying the 
pump does not take long if you have a band saw, angle plate and a mill. 
I will do a limited number for people that need the super low height pump.

BTW can anybody gas weld aluminum out there? Can you weld in the bottom
of a 1 X 2 inch hole 2 inches deep?
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org