I think that some of you guys must be kidding??? Think about the
enormous
expansion and increased compression created in your cylinders when
that
water explodes into all that POWERFUL STEAM. You remember when we
used water
injection in jet engines to increase the thrust. Jet engines don't
capture
that enormous increase during compression as do piston engines.
That water
is injected after the turbine wheel and expansion is passed on
down the
exhaust pipe.You'll be lucky if you don't blow the tops out of
every one of
your pistons.
Water tune up was running the engine at mid rpm and letting a stream
of water from a hose run into the carb. Worked fine. If rpm went too
low then the engine quit. Let cool and start it up. Virg
There is a HUGH difference between water vapor, fog, mist, or injected
atomization ... and a stream of water from a hose!
A fuel/air mixture of primarily gas is compressible, whereas water is not.
Even a quick dose of hose water risks filling a cylinder with more volume of
water than it might be able to contain (compressed) i.e. 22 c.c. of water
being compressed in a 20 c.c. cylinder head chamber.
Result, broken cranks, major engine damage! Do NOT EVEN THINK about taking
a hose to the intake of any engine.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org