Subject: New pump. External cast or machined.
From: Paul
Date: 6/4/2000, 11:12 AM

Howard is right. An external pump is pretty simple.
It could be hogged out of 1.5 inch thick plate.
Cut out on a band saw. A casting could be made somewhat lighter.

1.5 inch 1/8 tubing can be welded in for input and output ports.

The straight in to the impeller will make Jeff very happy indeed.
Jeff says you could probably zing the heck out of a pump like
this with no worry of cavitation. I am not so sure :-)

Mounting it low along side the engine may help cavitation slightly
as the intake of the pump is at slight increased pressure differential
compared to the high stock mounting. I notice Chevy is going with
a low mounting for their Cavalier four cylinder engines. 

This one uses the stock Mazda cartridge which you already have and that
has been suggested by Gerry Hess.

Another subtle advantage of this pump is the belt tension can be
independently set without using the alternator as an idler.

The drawback of course is two more plumbing connections and you need to make
a flange with inlet and outlet ports for the block.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

newpump3.gif