Also, is the 180-190 deg temp taken at the back of the waterpump housing
(where the
probe is on the stock 13b) or after the coolant has passed through the
radiator? And could
somebody refresh me as to ideal and max. temps in both places?
Thanks,
Lonnie
charles.harbert wrote:
Lonnie, it's at the back of the waterpump housing which is the critical
measuring point because the rad cap is right there. If you exceed temp and the
coolant boils, it will relieve itself. Rotaries are EXTREMELY dependant on not
overheating (boil over) because you will melt the silicone rubber water jacket
seals which allows combustion gases into the water passages. When this happens
it blows all the water out and overheats rapidly. You then must pull the engine
apart and replace these seals. It is not like a piston engine where you just put
antifreeze back in after you boil over. It is more like a blown headgasket. If
you ever get into boil over, imediately shutdown the engine, or reduce to idle,
if you can. You may save doing an overhaul.
The critical temps for the water jacket is the boiling point of your mixture.
I've had the water temp to 235-240 degF during ground idle, but my coolant (and
20 psi cap) is good for 250+. I use 60/40 water/propylene glycol (Sierra). I
would however suggest you keep it under 220, if possible.
It takes a lot more than 250 F to melt silicone rubber Chuck.
-50 to 520 degrees F. Marks ME handbook page 6-151.
What happens is the rotor housing over expand against the steel tension bolts
and when the engine cools off the housings are slightly shorter and then
the o-rings leak. Happened to Ed Anderson's plugs up engine.
As I understand it, propylene glycol is much worse than ethylene glycol
as far as heat transfer is concerned. I agree the temperature of the rotor
housing is critical and runs about 400 degrees F at full power and 5000 RPM near
the bottom of the leading plug. You want to extract as much heat from
that area as possible and the best way to do that is use lots of pure
cold water. Next is a moderate mixture of ethylene glycol. As little
ethylene glycol as practical. If you run your engine at 250 degrees F
you are asking for big trouble. It matters not what the boiling temp
is of the coolant. We also had a big go around on this awhile back.
Higher pressure caps are good.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org