Subject: JB Weld -- Aluminum Braze
From: Paul
Date: 6/12/2000, 4:09 PM


I think it is aluminum braze. I think the temp is about 750 degrees.
Aluminum melts around 1100 degrees F. Looks ideal for this application.


Bob Moore wrote:

I have used both "JB Weld" and the "Aluminum Braze" on the crankcase
of my 1/2 VW engine for building -up areas to drill and tap for an oil drain
and oil temp sensor.  Engine is now 10 years old and both are still intact.
http://www.wwd/user/bobmoore/engine.htm

Bob Moore


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org