BTW the turbo alone weighs 23 pounds. I don't have the exhaust manifold
off yet but I would guess it is around ten or twelve pounds.
Paul Lamar
Jeff Spitzer wrote:
Try 19 lb IIRC. I weighed mine before I started on my manifold design
effort. Now an update on that. I ran a stress analysis and found out I
was all wet. You can't bolt a billet exhaust anything to the 13B unless it
weighs 19 lb. The reason is as follows: The 4 10mm? bolts must be tight
enough to support the turbo and provide proper sealing pressure on the
exhaust manifold gasket. Therefore, it will take a known amount of side
force to slide the manifold (flange) under the bolt (based on clamping and
friction). When the manifold is 1600 deg and the engine is 200 the flange
under the bolts needs to slide about .050" altogether. If it doesn't then
thermal stresses result. Two choices: 1) Make a manifold that has some
(flexibility) pipe length between the port and whatever is growing in the
crank axis direction (just a couple inches will do it). 2) Make the flange
itself so freakin' heavy that the stresses associated with sliding under
the bolts doesn't cause cracks due to repeated thermal cycles (the .75"
that Mazda uses on the 19 lb part is about right) Good thing I didn't
build a bunch of these for my ACRE buddies, eh?
So...I've desinged a new solution to the "how to mount a T04 to a 13B for
minimum weight and size" problem but haven't modeled yet for share time.
Stay tuned.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org