Subject: Teflon encapsulated silocone water O-rings.
From: Paul
Date: 6/19/2000, 8:47 PM


Anybody.
If you have the engine apart please measure the distance from the
inside wall to inside wall of each o-ring grove the long way for me.
A steel tape measure will work fine. Also measure the groove depth
and width using at least a dial caliper.


Paul Lamar


Gaylen Lerohl wrote:

Measurements from my '88 13B:

with a steel rule- Outer water seal o-ring groove, inside to inside  12
inches (long dimension)

Close. I get 12 and 1/16
                          
Inner  o-ring groove, inside to inside:
9-25/35" (long dimension)

I think you mean 9 and 25/32

I get 9 and 3/4.


with a dial caliper- outside o-ring groove:  width 0.116", depth 0.065"
                            inside 0-ring groove:  width 0.142", depth
0.065"

Gaylen Lerohl

Yep those are right on. Looks pretty much the same.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org