BTW Tracy's motor mount is quite heavy.
A motor mount for a rotary engine using the drawings
on the ACRE NL and made from all 3/4 by .049 tubing
would weigh about 0.4 pounds per foot. 15 feet ought
to do it for most mounts so that is 6.2 pounds.
Add another 3 pounds for the hat section cross memember
and that will come to nine or ten pounds. Tracy's total
engine mount is about 28 pounds so a saving of 19 pounds
is likely.
Paul,
Mike Wills wrote:
Tracy's mount (and all tail dragger RV mounts except the RV8) incorporate
the main landing gear mount sockets and extra beef in the lower part of the
mount to absorb landing loads. So I think you are a little optimistic on
the weight difference.
If I recall correctly my conical mount for the Lyc weighed 13 pounds
before its surgery. After cutting off all the Lyc related tubing and
welding up the new tubing (.058 wall, a combo of 3/4" and 1") it weighed
about 14 pounds. The various mount brackets (4130 for the lowers and 6061
T6 for the uppers) added another 4 pounds. In hindsight I probably could
have shaved a pound or 2 from this by doing some things a little differently.
Mike Wills
Tracy used the stock RV4 mount plus a sub mount. The sub mount weighed
13 pounds and the stock mount weighed 15 pounds for a total weight
of 28 pounds. His Lyc rubber bushing also cost well over $100 buck each.
BTW I am thinking of making up a bunch of motor mount bit and pieces
such as the parts that bolt to the firewall and the part that the
Barry rubber mount is bolted to. Normally welded on the end of a bi-pod
or tri-pod. Is anybody interest in buying these ready made. Should be fairly
cheap when made in quantity.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org