Here is a picture of the EGR passage on a 2nd gen NA six port engine
center housing.
I would fill this small round hole with JB weld and port this
tiny intake passage with a carbide bur in a air powered die grinder.
Do not cut where you see the wear marks from the side seals.
You need this material to support the seals of course. Just cut up
and in streamlining the output of the port. I think you can get
templates from Mazdatrix or Racing Beat for this sort of thing.
Also remove the EGR valve from the top of the center housing
and cover and seal it with a bolt on plate.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org