Subject: rotor housing heat flux
From: Paul
Date: 6/27/2000, 8:39 PM

Jeff Spitzer wrote:

The picture that you sent of the temperature distribution around the spark
plug shows thermal gradients of about 10 deg C per 0.1 inches.  That's
almost 200 deg per inch SIDEWAYS!!!!  Do you still doubt that 400 deg/inch
is unreasonable in the heat flux direction.  I'm leaning more towards 1000
deg/inch by the minute!

Jeff Spitzer

Yes but the flame temp can vary widely over a short span. Think of an 
acetylene torch. Especially in a rotary with such a poor surface area
to volume ratio. The flame is rapidly cooled by the large area of 
relatively cold metal.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org