Subject: 86 RX7 running and oil cooler/ radiator sizing
From: Paul
Date: 6/28/2000, 9:12 PM

 
Quick question: My wife is finally allowing me to sell her '86 RX-7, which
I am
trying to do on the internet. However as a EAA member, UL and GA pilot I
was
wondering if a homebuilder would be interested in buying it for the engine
to use
on an experimental.


norm2 wrote:

Dave-
If that is NE Missouri, and it is a 13B, I may be interested.

Also-
I am about ready to put the engine back together.  Are the teflon seals
available, or are they vaporware at this point in time?  Same with the 6port
intake flange kits?  I hope to have the engine ready to mount in two months,
and it is time to line up the supplies.

Both are on order. The six port flanges should be done any day as Robert
has the material. PL


I will be mounting a pair of 40A alternators on the engine, is it worth
converting it over to a multivee serpentine belt?  Or leave it alone.  I am
going to slow down the waterpump.  I also have a scheme to direct drive one
of the alternators, but I suspect that if a person throws a belt you are
going to need to get on the ground because you will run out of cooling
before you run out of battery.

I looked at George Grahams installation a week ago, he had a very clean
thermostat housing that I will also try to replicate.  Also some interesting
comments about how it is required to circulate coolant from the heater
output fittings to get proper cooling.  He got that info from some racers.
I don't know if you end up with some dead ended passages by blocking that
fitting or what.  Anyway, his circuit is to run one cooler on the heater
loop, and a second cooler on the thermostat loop.  The bypass is always
blocked.  He claims the cooling settled right down with that system.

As far as Oil cooling, I think he is using a Setrab 625 cooler (2x7.5x13).
My inclination is to use a Setrab 634-10 (2x10.25x13) with the AN10 fittings
from Mazdatrix.  Radiators look like a pair of 1.5 x 10.25 x 13 exchangers

Anyone care to critique the cooler sizes?

regards-
Norm


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org