Subject: 86 RX7 running and oil cooler/ radiator sizing
From: Paul
Date: 6/28/2000, 9:58 PM

norm2 wrote:

snips...

I looked at George Grahams installation a week ago, he had a very clean
thermostat housing that I will also try to replicate.  Also some interesting
comments about how it is required to circulate coolant from the heater
output fittings to get proper cooling.  He got that info from some racers.
I don't know if you end up with some dead ended passages by blocking that
fitting or what.  Anyway, his circuit is to run one cooler on the heater
loop, and a second cooler on the thermostat loop.  The bypass is always
blocked.  He claims the cooling settled right down with that system.

snips...

regards-
Norm

This makes sense but I don't think you need another cooler. Routing the heater
outlet on the back of the block to the input side of the main rad would work
as well. What this does is bypass some of the hottest coolant from its
normal path and function of warming up the cool side of the engine so the engine 
does not go into a banana shape looking at the engine from the top. This would
probably improve the flow rate through the hot side of the engine a little
bit due to less overall restriction in the block to coolant flow. The down 
side of course is you might get more banana :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org