Subject: Coking on the side of the rotors.
From: Paul
Date: 6/28/2000, 2:34 PM



Hi Paul,
There is a combination of four things that cause all of the carbon and oil
coaking to form on the sides of the rotors. Obviously, the first and most
common cause of excessive carbon is when the rotor oil seal O-ring harden or
the seals themselves fail, allowing excessive oil to pass around the seals
and cook onto the side of the rotor. The other three conditions are tied to
the fact that the sides of the rotors, between the side seals and oil seals,
are exposed to the intake charge as the rotor tip crosses over the intake
ports. The gasses from the EGR, the primary port oil injectors and carbon
that is pulled up from the combustion area and then pushed into the intake
port, then pushed into the rotor sides by the trailing side seal. A final
thing to consider is blow by. If the side seals or corner seals have weak or
stuck springs, excessive blow-by can occur.
I hope this helps. I would put most of my bet on the first and last scenarios.
Bruce

Thanks Bruce. I hope Tracy took some pictures of his engine when he
took it apart after 800 hours with no EGR. Tracy?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org