Subject: Stuck seals in rotor.
From: Paul
Date: 6/28/2000, 11:51 AM

Ken Powell wrote:

Paul,
I have disassembled 3 engines from junkyard cars that had no body damage
- these cars were junked because the engines would not run.  All 3
engines looked just like the pictures you posted.  All 3 cars had less
than 115,000 miles.  I think that dirty oil killed these engines.  I
asked the group how to clean rotors that looked like this last year.
Boy, did I ever get a lot of response.

Ken Powell


Carb cleaner is the answer but don't allow it to touch the bearing
material. I showed those pictures to Jim Mederer (Racing Beat) and Dave Lemon
(Mazdatrix)  and they both said oil o-ring failure. Perhaps caused by an 
overheated rotor due to failure of the oil thermostat in the noes of 
the e-shaft. I need to check a few things. I just re-read Jim's catalog
and he has been using Amsoil synthetic for years with good results.
If Amsoil is as good as Mobil I the coking temperature is much higher
than regular motor oil so that should cut down on these types of deposits 
along with the teflon encapsulated silicone O-rings.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org