Subject: Chemistry 101 (was "Water jacket crude accumulation")
From: Paul
Date: 6/29/2000, 8:37 AM

Russell Kent wrote:

Russell Kent wrote:

I'd like to point out that the air bubble in the cooling jacket isn't an infinite
supply of oxygen.  As the air's oxygen is used to oxidize the "stuff" to make crud,
there's less oxygen available.  So the question is, is there enough oxygen in the
small trapped air bubble to make all of that crud?  My gut reaction is "no," which
means that there is something else going on in addition to any oxidizing action.

Paul wrote:

Water is H2O. Perhaps by heating it, oxygen and hydrogen  is liberated.

Unless you're heating it to a plasma state (which we aren't), there's essentially no
liberation of oxygen from heated water.

True, the pressure is increased greatly but that is vented off by the radiator cap.
There may also be dissolved gases in antifreeze.

When you boil water in a pot on the stove little bubbles mysteriously appear
at the bottom of the pot next to the hot surface. How did that gas get
down there in the first place?

There's two different bubble sources, one early in the heating process, and another
late in the heating process.  The first bubble is dissolved gases (atmospheric gases
like nitrogen, oxygen, argon, carbon dioxide, etc.)  As the water is heated, the
dissolved gases come out of solution.  They form on the surface of the vessel rather
than in the middle of the fluid because the vessel's surface provides accretion points
(sort of similar to the way raindrops form in clouds).  The second bubble is a pocket
of steam.  As the vessel heats, points of its surface reach temperatures above the
boiling point of the fluid.  The fluid in contact phase changes to steam.  But since
the gas phase is less dense than the liquid phase (practically by definition), it tries
to rise in the fluid.  As soon as the gas pocket tries to pull away from the surface,
it's contact with the heat source (the vessel wall) cannot provide enough heat flux to
maintain the bubble (which is leaking heat to the surrounding fluid), so the bubble
collapses.

Trivia: use boiled water to make ice cubes, and you'll end up with cubes that have
almost no trapped air bubbles.

Back to the engine.  The coolant (a mixture of water, and anti-freeze, which itself is
a mixture of other things) has dissolved gases.  It should come as no surprise that the
dissolved gases are the same ones in the atmosphere.  I'd guess that the ratios are the
same, too, but I don't know that for certain.  Assuming that they are, then the
majority of the dissolved gas is nitrogen (78%), oxygen (21%), argon (1%), carbon
dioxide (0.03%), and other gases (< 0.01%).

So only 21% of the air pocket, plus 21% of the dissolved gases is oxygen (actually less
than that since the percentages I used are for dry air; moist air has about 12% oxygen
IIRC).  That ain't much oxygen.

Paul, take a sample to the local university chemistry department and ask them to
identify it with their chromatograph.

Russell Kent

Good idea Russell I will give that a try. I can also send you some.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org