Subject: Do I need to replace this side housing?
From: Paul
Date: 6/30/2000, 1:21 AM


The engine I brought home from Srictly Mazda was in great shape except for
this tab on the rear side housing which I noticed has been broken off.  I am
afraid that this is going to be critical to mounting the PSRU.  I am also
afraid that the fix is going to be getting a new side housing.  Any input?

Dave Leonard


Come to think of it Dave, Tracy uses a simple 1/2 plate aluminum adapter
for the re-drive. These are not hard to make. If Tracy has cut away the 
material needed to pickup some other bolt boss you could always 
make your own.

BTW There will be no airshow so Santa Paula will be open.
You should get the airplane sooner than noon as that will not
leave much time at Santa Paula. It must be at least a two hour
flight in a 140. I will be leaving about 4 PM I guess because
Robin needs to work the midnight shift at UAL and sleep a bit before.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org