Subject: Reason for oil seal failure
From: Paul
Date: 6/30/2000, 2:31 AM

This, I think, is what caused the sludge build up on the side
of my rear rotor with a subsequent stuck apex seal and loss of
compression on the back rotor. The engine unbeknownst to me did 
not have a thermostat in it when I bought it so it was probably 
overheated. Never ever remove the thermostat unless you block
the bypass. If you are buying an engine unbolt the thermostat 
housing and see if it is there. The engine is probably a core
if it is missing.

The extra heat  probably affected this oil seal.  I hesitate to measure 
the rotor housings to delay the really bad news of rotor housing
warpage or shrinkage.

Teflon coated silicone o-ring are the best you can get. These
should tolerate more heat and mitigate these kinds of problems.

I am also getting ready to try turbine oil in this engine when
I put it on the dyno/test stand.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

brown-oring.jpg