Charlie Kuss wrote:
Mike,
In the 14 years since port fuel injection came into wide spread use (1986) I have
never seen an injector create a dead short. That does not mean it doesn't happen,
I've just never seen it. The most common electrical injector problem is water
ingress into the harness connector at the injector. This is easily determined by
removing the plug from the injector and inspecting the contact points on the wiring
plug & the injector. The metal will be green (oxidized copper). This is only common
on cars with poorly designed wiring harnesses. (Nissan Maximas & 300ZXs come to
mind) Use of waterproof connectors eliminates this possibility. RX-7s have this
(waterproof) type of wiring plug.
The most common problem with injectors on modern autos is the needle and seat area
getting dirty due to sludge build up in the intake tract. This causes poor idle and
high hydrocarbon emissions. Normal part and full throttle power are not greatly
affected. In an aircraft application, the most likely complaint of this would be
the engine stalling during power being reduced to idle. (Final approach) The engine
would restart normally however. Paul's suggestion to block off the EGR ports will
help eliminate this "sludging of the intake tract".
I have only seen 1 instance of injector failure due to poor wiring other than that
caused by moisture. I had 1 customer (Mitsubishi) who lost power to 1 injector (4
cyl. engine) due to a poor connection between the harness connector at the
computer. This particular problem drove me nuts for days. Visually, the connector
looked fine. Naturally, it tested fine when I probed the circuit with a test light
at the connector. It simply did not make good contact with the male connector on
the computer.
Most manufacturers supply power (+) to the injectors through the ignition circuit.
The computer controls the injectors by completing the ground side of the circuit.
This design prevents a shorted injector from destroying the computer. A shorted
wire between the injector and the computer (ground side) will cause the injector to
stay open 100% of the time. At low power settings, this would cause the mixture in
that rotor chamber to go very rich. At cruise power, the rotor would still produce
good power (albeit a bit rich).
A short in the power supply (+) side of the circuit would blow the fuse supplying
power to all the injectors. This would be a bad thing, as it would affect all the
injectors. On most autos, 1 fuse supplies power to all the injectors.
Perhaps it would be wise to use separate power supply wires to the injectors of
the 2 rotors. This way, even a short in the injector or it's positive supply wire
would only affect 1 rotor (or 1 injector of both rotors). This would mean you could
still produce 50% power, rather than losing all power due to lack of fuel supplied
to both rotors. I believe Tracy has taken this into consideration on his system. If
I remember correctly, his computer design completes the circuit to the primary
injector of rotor #1 and the secondary injector of rotor #2 on one circuit. The
secondary injector of rotor #1 and the primary injector of rotor #2 are supplied on
the second circuit.
Question for Tracy Is my statement above correct? Does it apply to only the
ground (between injector and computer) side of the circuit? Would you suggest 2
discrete power supply circuits on separate fuses? It seems to me that supplying
power to the injectors as I have described regarding the ground side would make for
a safer system.
Charlie Kuss
RV-8 priming 1 piece main wing skins
Boca Raton, Fl.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org