Subject: ugh - E-shaft moving
From: Paul
Date: 7/1/2000, 6:33 PM

John McLaughlin wrote:

I've just read the post about leaving the e-shaft bolt in to keep the
e-shaft from moving back and forth while removing the flywheel. The good
news is my e-shaft bolt and flywheel nut came off easily using Paul's setup
(I used 42" 5/16 3x3 angle) but in trying to get the flywheel off the
e-shaft has been moving back and forth.

Two Questions:

What should I inspect for damage from the e-shaft moving? It seems to move
smoothly.

Is there an alternative method to the flywheel puller for removing the
flywheel?

thanks - John

I think it bottoms out on the center housing hole but I am not sure.
Check the fillet between the rear main and the rear rotor lobe for
nicks. There is a very remote possibility that could eventually cause
a fatigue crack. To my knowledge its never been known to happen
however but that is the highest stress area on the shaft.

I use a large heavy leather hammer and give it a good wack.
A block of wood and a large steel hammer would also work.

BTW here is a picture of my e-shaft passing the run out test. It was
perfect!

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

run-out-test.jpg