Subject: Atkins Rotary Goes "Single"
From: Paul
Date: 7/5/2000, 9:44 PM

George Moore wrote:

Paul,
   Am I losing it or missing something, besides good sense ?  What good
is a 100 hp single Rotor "package" that weighs in at 175 lbs, not even
counting the radiator ?  Couldn't you get that same "package" in a 13B,
160 hp, 2 rotor, for another 35 lbs or so ?


That is the major problem with the one rotor. That rear housing alone weighs
about 45 pounds. It is in dire need to be made from aluminum. The front housing
is a lot lighter. That press release weight number might include a cog belt re-drive.

On the other hand an O-200 100 HP is 190 pounds but you don't need a rad
or PSRU.

The other major problem is a one rotor cost more than a two rotor because
of the cost of cutting down the e-shaft and the special counter 
weights required. I think a one rotor with turbo or peripheral port
would make more sense because then it would be about 115 HP NA and
maybe 150 HP turbo.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org