George Lendich wrote:

Paul,
I can see how you make the ferrals - simple turning job, but how do you make
the split
casing, is that pressed or turned.
George (down under)

Your turn it then cut it in half either with band say or slitting saw.
The cut angle is not critical.

Paul Lamar

Boy did I screw up this message. Lets try it again

You turn it then cut it in half either with band saw or a slitting saw
in a mill. The cut angle is not critical. The split clamp is then
held together with an ordinary hose clamp.

That is what happens when the wife is talking in one ear :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org