Subject: Bill Hughes fabricator address & phone #
From: Paul
Date: 7/6/2000, 6:46 PM

Mike Wills wrote:



Hi Paul,

You can reach Art Luther at artscustom@msn.com.

My rotary powered RV-6 with Bruce Turentine's modified engine and Tracy's
engine control unit is nearly ready to go.  The ECU is a fine design having
total redundancy for the computer, ignition, and fuel injection.

  Art did the dynafocal mount for the 13B and the prop shaft was located in
exactly the right spot.  Weight and balance came out perfect.  The intake
manifold folded over the top giving the desired 18 inches per each of the
four tubes (it is a four port turbo engine) and the tubes connect in a
semicircular U giving dynamic charging.  I needed one tiny bump in the
cowling.  I eliminated two larger bumps necessary for the Subaru
six.  The SS
exhaust manifold and muffler is fine.  I used dual large high flow oil
coolers and dual oil filters, both in parallel for high flow.  I will have
temperature test data within two weeks.  I'm turning and 68 inch prop
with a
76 inch pitch.  It's a pretty big bite.  I don't need Tracy's 2200 feet per
minute climb.  Efficient fast cruise is my goal.

Keep up the important work Paul.

Sincerely,   Bill    (727) 772-7773

Bill,


Mike Wills wrote:

  Pictures please. Lots of pictures !!!

Mike Wills

Here is an old one.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Bill-Huges-intake2.JPG