Subject: Bulents 13B Cosmo water pump.
From: Paul
Date: 7/8/2000, 3:15 PM

Bulent Aliev wrote:

This pump is "Black Magic" to me: twin thermostats, vacuum valve on top of
them...... Also too tall. I would like to lower it and get rid of the two
thermostats and vac. valve.  What do you think? Can I (you) cut it down and
just reduce the height of the pump without doing anything else?
Bulent


It is pretty simple. There are two thermostats. If one bypass is open, only a little
water is bypassed. If both are open, a lot of water is bypassed for real quick
warm up. When both bypasses are closed and both outlet passages are open to the
rad there is somewhat less overall restriction in the thermostats to water flow 
than with the one thermostat type pumps. Sort of like taking your thermostat
out in a piston engine for more flow and better cooling.

BTW the very best way to control engine temperature in an aircraft engine
is with cowl flaps and NOT with water thermostats. We decided this about a year
and a half ago. Less aerodynamic drag because less air is flowing through
the rad. Better miles per gallon.

Here is a picture of Mike Hirshfelds movable rad flaps on his water cooled 
Ford V6 seen at Arlington.

If I cut it Bulent you will have to weld on it so you might as well go
the whole route. Do you have the part that holds the pressure cap?
The pressure cap must be placed in the highest point of the system.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Mike-Hirshfeld-flaps.jpg