Subject: Light weigh aluminum rotos.
From: Paul
Date: 7/8/2000, 11:02 AM


Historically, the problems with aluminum rotors have been: 1) "pounding out"
of the apex seal slots, 2) large differential in expansion coefficient with
gear and bearing, leading to high stresses on gear retention and inadequate
bearing retention. The MMC material properties may well make an aluminum
rotor possible. It might be possible to cast in a ferrous apex seal slot
insert, however at the expense of cooling the seal to some extent.

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org