Jeff, Here is a better shot of the feed in area to the impeller.
BTW bulent you do know you will have to cut, fit and have
welded in the new partition and outlet tube do you not?
I will make the 1-1/4 ID out let tube and cut a hose barb on
it with my lathe. You will need to weld the old pressure cap
fitting on the outlet tube so the pressure cap becomes functional.
Also a boss must be made and welded on for the water temp sensor if you
want to mount it on the outlet side of the block.
Paul Lamar
Jeff Spitzer wrote:
It looks better than most but doesn't address the real issue of turning too
sharp too close to the impeller. There's still no radius on the leading edge.
Jeff Spitzer
Looks like there is enough meat there so that could be done with a
die grinder.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org