Paul wrote:
Here is the shot stright in. The brown part at the bottom of
the hole is the curved wall where the water comes out of the block
The new partition is installed. Of course the tube is not yet
welded on.
Paul Lamar
Bulent Aliev wrote:
I Like it Paul! Good work.
Thanks Bulent. I put about four hours into it. I will ship it back
tomorrow or the next day.
I think if someone were doing a lot of them that could be cut way down.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org