Subject: Long EZ stock mnt bolts
From: Paul
Date: 7/10/2000, 1:45 PM


Bill Freeman wrote:

Paul,

Each corner of the stock LE engine mnt has two 1/4"
bolts at 90 deg to each other.  The steel tube
nestles into the corner of a 1" x 1" x 1/8" 2024T6
alum angle.  The angle is bolted thru a 1/8+ layup
of glass over a wood insert in the spar and also
thru the wood longeron, four 1/4" bolts per angle
bracket.  It is common for the 150 hp guys to use
1.5" x 1" x 1/8" angle.  I'm not sure if this is just
being careful or in response to actual failures in the
field.  The eight 1/4" bolts feeding into sixteen 1/4" bolts
seems pretty sufficient to me.  On the VE that I
did the crash investigation on, the mount bolts were
intact even tho the A/C was shredded, literally.

Bill

Nobody told me it was two 1/4 inch bolts per corner. I thought
they told me ONE 1/4 inch bolt per corner :-)

Klause had one of  those aluminum angles fatigue and crack.
Best to replace those with 4130.


Perry Mick wrote:

The LongEZ mounts are different than those used in the Cozy IV
and the Defiant.  I believe the Cozy IV and the Defiant use a
single bolt in each corner, the bolt being parallel to the long-
itudinal axis of the plane.  There are 1/4 inch aluminum inserts
glassed into the plywood firewall.  I'll send the details later,
as I just got back from Arlington.

--
Perry J. Mick
Mick Duckt N7XR
http://www.ductedfan.com


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org