Subject: water pumps. speed, and back pressure
From: Paul
Date: 7/10/2000, 8:06 PM


Interesting discussion on cooling. Common sense says that a big radiator and
oil cooler are better than smaller ones, all else being equal- adequate air
flow through them, etc. As far as the water pump goes, why should you want to
run coolant really fast though the engine block? If you were to use a garden
hose to run  water through an  engine putting out max power, I doubt that you
would worry about running a huge volume through the block, due to the huge
temperature differencial between the water and the engine. If you were to
have a small temperature difference, you would probably want to run the
coolant much faster. 

If you have restrictions in your system and you have to
run your pump faster and at higher pressures to overcome them in order to get
adequate flow, then you end up imparting a lot of heat into the system. On
our fire engines, we have to be careful to  open up a re-circulating valve
when we run the pump up to pressure without flowing water. If you were to run
a pump up to pressure for more than a minute or so with no water flow, the
water will get hot enough to boil. 

Think of all the friction inside the
coolant system of any given engine- all the bends, rough spots, square
corners, etc. all of these things cause friction and slow the flow of
coolant. In the block itself, some turbulence is probably beneficial. In the
radiator, the slower that the coolant can go through it shedding heat, the
better. In the pump and the hoses, I'm sure that turbulent flow is
detrimental.  I'm not sure what I'll do to my pump, but I'm pretty sure that
I'll attempt to smooth the path of the coolant.

These are just my humble and uneducated opinions, and should not be construed
to mean that I know what I'm talking about.

On and earlier posting it was stated that Tracy Crook's oil cooling problems
were resolved. What was changed?

Brian Trubee
Redmond, Wa

Just got off the line with him. He improved the aerodynamics of the duct.
His inlet duct to the stock oil cooler was pretty bad.

He marveled at how much difference it made.

Paul Lamar

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org