Paul,
I see you come out of this pump with a 1 1/4 inch pipe. A logical place for
a Wiggins coupling.
I would suggest that you make your production run of Wiggins couplings bored
to a welding fit for the 1 1/4 inch pipe, also.
It is a heck of a lot easier to bore, grind, file, (whatever) to fit a larger
pipe than it is to fill in a 1.395 hole to match a 1 1/4 pipe.
For what it's worth.
Bob Darrah
That is 1-1/4 inch ID tube. That tube has 1.5 inch OD 1/8 inch wall.
There is a big difference between pipe and tube. Pipe has entirely
different dimensions that have nothing to do with the "size".
Yes you will have to cut off the bump on the hose barb and bore the
wiggins couplings if you want them to fit the water pump.
The stock wiggins will be bored for 1-3/8 tube OD .049 wall tube but
there will be enough meat to bore them out for larger OD
tube or pipe.
I am not entirely sure people will pay what it cost to make wiggins
couplings. I think we would have to charge at least $35 each. Not
entirely sure about this but I think it highly unlikely the price
will get much below $25. Is everybody willing to pay that much each for
a minimum of the needed four wiggins couplings?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org