Subject: How do you set timing on a '91 rotary
From: Paul
Date: 7/12/2000, 8:39 AM

Richard Ramsey wrote:

Howdy Yall,

    I have a 91 rotary engine that is out of time. The distributor is
molded into the front housing. So I can't simple pull the distributor to
set the timing. From looking at it, the only way seems to pull the front
motor housing. Is there another way? I am a 1st gen guy. I have 6 first
gen rx-7's and recently bought this 91 2nd gen.

If they don't have big wires coming out of the top we call them
a crank angle sensor.

The crank angle sensor is molded into the front housing? I don't think so.
There is a small nut behind the idler pulley and below the top 
of the crank angle sensor for setting the timing. Are you sure it is
not a 92 or later engine? PL


    The person who I bought it from took it to mechanic and it came back
in worse shape. From the looks of it, the mechanic took the front
housing and oil pan off. from I can tell the motor was setup for several
months and lost compresssion in #2 rotor. I shot some oil into #2, and
cranked the car, and noticied that the afterburner started glowing.
After checking timing, which appears to be atleast 10 degress off, I
couldn't come up with any other way to change timing.

    I would appreicate any suggestions from the most intelligent group
on the net (is that enough sucking up). I have been lurking here for
over a year now (8178 messages), and learned so much about the rotory.
It is one of the main reason I have bought so many rx-7's. I am a pilot
trying to make my mind up on what type of plane to build. So far the
only decission I have made is to use a rotory.

Thanks,
Lurker Richard

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org