Subject: How do you set timing on a '91 rotary
From: Paul
Date: 7/12/2000, 11:26 PM


Richard Ramsey wrote:

Howdy Yall,

    I have a 91 rotary engine that is out of time. The distributor is
molded into the front housing. So I can't simple pull the distributor to
set the timing. From looking at it, the only way seems to pull the front
motor housing. Is there another way? I am a 1st gen guy. I have 6 first
gen rx-7's and recently bought this 91 2nd gen.

If they don't have big wires coming out of the top we call them
a crank angle sensor.

The crank angle sensor is molded into the front housing? I don't think so.
There is a small nut behind the idler pulley and below the top
of the crank angle sensor for setting the timing. Are you sure it is
not a 92 or later engine? PL

I must apologize for my stupidity and ignorance. The only excuse I can use is
my medication is affecting my brain. The nut had a plastic cover over it. I
guess that is what threw me. I appreciate the help. After I set the timing,
the car cranks up fine. Now I belive I have to locate a vacuum leak. The car
won't idle, but seems to run after 2000 rpms.


Thanks,
Lurker Richard

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org