Subject: How do you set timing on a '91 rotary
From: Paul
Date: 7/12/2000, 11:42 PM


Richard,
 > I had a similar problem on the 1st rotary that I rebuilt.  I had
installed
the
 > crank angle sensor 'off' by 1 tooth.  The engine would run, but the
exhaust
 > manifold would glow red.  When I finally rotated the CAS by one tooth and
 > retimed the engine, it ran great.  I had a really hard time finding my
error
 > because I thought that I had probably installed some of the smog stuff
 > incorrectly.
 >
 > Ken P.


I have been wondering how to get the crank angle sensor lined up.  Is there a
procedure outlined in the Haynes manual?

Dave Leonard

Page 155 If you have the 86 through 91 Haynes manual Dave. Rotate
the e-shaft clockwise until the leading mark on the pulley
is aligned with the pointer. There is a punch mark on the CAS gear 
and mark on the CAS housing you align and then install it.
I will bring the manual down with me if you don't have one.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org