The crank angle sensor is molded into the front housing? I don't think so.
There is a small nut behind the idler pulley and below the top
of the crank angle sensor for setting the timing. Are you sure it is
not a 92 or later engine? PL
It just LOOKS as if it is molded in (I thought the same thing at first).
Pop off the black plastic piece, and remove the timing nut, then the whole
thing comes out. I just dont know how to get it back together correctily :-)
Dave Leonard
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org