Subject: aluminum tube bending
From: Paul
Date: 7/12/2000, 7:42 PM


Paul... The trick is to take a gas torch and produce a carburizing flame. Take
that flame and coat the aluminiun with it. After you have done that, change
your torch back to a slightly less than fully feathered flame and burn the
carbon off. That should pretty well anneal the aluminium.  That is also the
way you can pre-heat an aluminium casting or thick aluminium stock prior to
T.I.G. welding so you don't add a lot of misplaced heat which would distort
the part.      JIM DANA

Thanks Jim. We need to try that on an aluminum tube bender.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org