Gary Wolf wrote:
Paul,
The problem with bending aluminum tube is that it does not want to be
stretched nearly as much as steel tube will happily accept. Annealing only
accentuates the problem because it becomes more likely to begin necking
down. It is sort of like pulling apart a piece of cheddar cheese. On the
other hand if it is too brittle it snaps at about 15 degrees of bend just as
it goes into the plastic deformation stage.
I use a flexible mandrel inside the tube to support it against
collapsing. It is made of truncated balls joined by steel links. With a
steel tube, the material work hardens as it passes over the first ball and
then only needs to be sported by the succeeding balls. With aluminum it
generally wants to neck down and part as soon as it passes the first ball.
The solution is to encourage the tube to thicken on the inside of the
bend instead of thinning on the outside. I can't figure out how to do this
economically but since it was commonly done in England in the Fities by guys
who were working in rudimentary shops under railway arches, I am missing
something that must be obvious.
In actual fact, it requires a lower class of tooling to get a good
quality bend on stainless or 4130 than it does for good old 1010 mild steel.
Both of these materials work-harden faster and are more self-supporting,
taking some of the work load away from the mandrel itself.
I bend almost every size from 3/8" to 2-1/4" OD in wall thicknesses from
.050 to .1875.
Gary Wolf
How about just heating it on the inside with a torch after it is on the
mandrel. Burns Stainless sells aluminum bends for big bucks. Perhaps you
could visit and see how they do it :-) Do you use a lubricant?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org