Subject: Beading & Alum Tube Bending
From: Paul
Date: 7/13/2000, 3:28 PM

Ken Powell wrote:

I remember an article in Experimenter showing how to make a tool to form
the bead on a tube.  This was basically a piece of steel tubing just
undersize from the alum tube to be beaded.  The steel tube had 3 holes
placed evenly around the circumference of the tube in which a steel ball
was placed (1 ball in each hole).  The steel tube was threaded on one
end and received a tapered driver that would force the 'balls' outward
when screwed into the outside tube.  This forced the balls outward and
expanded the aluminum tube when the entire steel assembly was rotated.
Easier to do than to explain.  If this doesn't make sense I will look
for the old article.

Also, no one has mentioned Tracy's method of building the bead with
fiberglas - this would be an easy alternative and has been proven to
work.  Does the cooland temp get to hot?

Lastly, Parker makes some beading tools and they are listed in the ACS
catalog but I don't remember if they make a size this large (1.25").

Here is a cheapy idea for mandrel bent intake tubes - use a steel
mandrel bent 'curve' and epoxy the aluminun runners to the steel.  This
shouldn't add to much weight and would be easy to locate the correct
parts cheaply.

Ken Powell


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org