Subject: aluminum tube bending
From: Paul
Date: 7/13/2000, 3:29 PM


Paul... The trick is to take a gas torch and produce a carburizing
flame. Take
that flame and coat the aluminiun with it. After you have done that,
change
your torch back to a slightly less than fully feathered flame and burn
the
carbon off. That should pretty well anneal the aluminium.  That is also
the
way you can pre-heat an aluminium casting or thick aluminium stock prior
to
T.I.G. welding so you don't add a lot of misplaced heat which would
distort
the part.      JIM DANA

Thanks Jim. We need to try that on an aluminum tube bender.

Paul Lamar



To anneal aluminum I make marks on the piece with a black magic marker. You
can
then use a propane torch to heat the piece until the marks just disappear.
Immediately
quench the piece in water, should then be dead soft.
Lonnie


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org